In order to ensure maximum safety and reliability, regardless of the age long should frequently check the SKF Bearings, pay attention to wear early warning signal: the deceleration is not normal, including any rotation of the friction noise or flying wheel assembly during cornering.
Here's the point of view under which warning, suggesting that the fault may occur:
(1) to hear the noise issued by the SKF site, first of all, it is important to find the noise occurred. There are many moving parts that may generate noise, it could be a number of rotating parts and rotating parts, contact. If the confirmation is a Bearings noise, may have been damaged and need replacing.
2 because of the similar working conditions before both sides of the failure, so even if the only bad one is also recommended to replace them in pairs.
3.SKF more sensitive, in any case need to adopt the right approach and the right tools. Bearings parts can not be damaged in storage, transportation and installation process. Require greater pressure on the indentation, so they need special tools. Be sure to refer to the manual.
The installation should be in a clean environment, the small particles into the Bearings life will be shortened. Replacement to maintain a clean environment is very important. Not allow the tap with a hammer, be careful not to fall to the ground (or similar improper handling). Response to the shaft and seat status to be checked prior to installation, even if it is slight wear and tear can lead to with the bad, causing damage.
Do not attempt to open SKF or adjustment ring, otherwise it would ring damage lead to the entry of water or dust. Even the ring and inner ring raceway are being damaged.
Equipped with ABS ring, a magnetic thrust ring, thrust ring can not be collision, impact or collision with other magnetic field. Removed from the box prior to installation, so that they stay away from the magnetic field, such as the use of motors or power tools.
Many of SKF Bearings are sealed, do not need to grease the entire life period. Not sealed, such as double row tapered roller must be installed and grease lubrication. Cavity of different sizes, it is difficult to determine to increase the number of oil, if too much fat, when the Bearings rotates, the excess grease will be oozing. General Experience: At installation time, the total amount of fat accounted for 50% of the gap.


Other News:
SKF Bearings in failure early warning signals
Adjust the trajectory to reduce TIMKEN bearing noise
FAG bearing installation use and maintenance of Note
FAG Bearings installation coordination and adjustment method
FAG bearing the high temperature and high lubrication
Failure analysis of the causes of the NSK Bearings
FAG bearings corrosion causes and prevention
With the appropriate assurance FAG bearing life and feasibility