1, select clean, dry places in dealing with TIMKEN bearings, cleaning and maintaining the tools and worktable;
2, do not open before the bearings are mounted TIMKEN bearing package;
3, if the TIMKEN bearing installation required before acceptance or other package is not for any reason, you can take the following approach:
A. TIMKEN bearings will be installed within a relatively short period of time, are on its surface coating layer antirust oil and place on a clean container;
B. TIMKEN bearings are not installed in the short term, its surface coated with a layer of antirust oil and repackaged under the original container;
4, drum, box, tube or check lubricant injection are clean and/or closed, verify that the bearing seat is clean and free of cracks, no trace, burrs or any other defects;
5, for grease lubrication, you might feel new bearings with grease is not cleaning, TIMKEN bearing small or used as a fast-moving, whether he was lubricated with oil or lubrication, using kerosene TIMKEN bearings or warm light oil to remove rust. However, bearings with seals or shields must not cleaning and heating.


Other News:
What protective measures should complete during installation of TIMKEN bearings
INA bearing three installation methods
TIMKEN bearings what are the common fixing method of inner ring
Ordinary maintenance of INA bearing four considerations described
How to ensure the application of compressive strength of NSK bearings do not change
TIMKEN bearing analysis of maintenance and repair methods
Introduction to installation INA bearings must be matters for the attention of
Common TIMKEN bearings which are corrosive