Bearings installation is good or bad or not, will affect the accuracy of INA bearings, long life and performance. Therefore, please fully research on bearings installation, follow the operating standards, contains the following items for bearings installation.
Cleaning bearings and spare parts have grease lubrication of bearings and double-sided oil seals or shields, seals without cleaning before the bearings are mounted. ）
Second, check the bearings size and finishing of the relevant parts
Three INA bearings installation, installation method should be based on the bearings structure, the size depends on the size and nature of bearings parts fit, pressure should be added directly in the tight fit have rings on the face, shall not pass through the rolling pressure bearings installation generally uses the following methods: (1), keep the bearings and the surrounding clean. Even eye can't see small dust, also will have bad effects on bearings. So, you want to keep around clean, so that dust will not incursions into the bearings. (2), carefully used. INA bearings a strong impact in the use, will have scars and indentation, became the cause of the accident. Serious cases, cracks, breakage, so care must be taken. (3), using the right tools. Avoid replacing it with some existing tools, you must use the appropriate tool. (4), pay attention to corrosion of bearings. When operating the INA bearings, Khan will become the cause of rust on the hand. To note that the clean hands operation, it is best to try to bring a glove.


Other News:
Introduction to installation INA bearings must be matters for the attention of
Common TIMKEN bearings which are corrosive
TIMKEN bearings how to run periodic checks
Methods for detecting FAG bearing damage cause
The specific way to determine whether the FAG bearings need to be replaced
Selection of SKF bearings with low noise
Considerations for selecting NSK bearing
Nine species of SKF bearing failure analysis