All stainless steel bearings prior to installation should be stored in their original packaging. They need to stay in a clean and moisture-free, relatively constant temperature of the environment. FAG bearings should stay away from dust, water and corrosive chemicals. Shakes and vibrations would forever destroy the mechanical properties of the bearing, in the handling and storage must be avoided during shaking.
Satisfactory FAG bearings work began on the right select. From the outset, bearing Designer by selecting the correct bearing for different applications to extend bearing life and equipment performance. This process has to take into account a number of factors, such as load, stiffness, bearing life prediction, environment and so on. Basically, all bearing must be level to save, because some of the heavier bearings after a long vertical drop, probably due to its own weight and deformation.
Grease-coated in advance (or sealed) bearings require special care, because the fat density will change after it has been stored for a long time. So when the bearings when used for the first time, there will be a degree of rotational noise. So set aside time this FAG bearing should be controlled according to the FIFO principle.
In normal running process, how to moderate the FAG bearings lubricated bearing in maintenance and repair work is also an important element not to be ignored.
The smooth smooth oil bath bearing in the ordinary way, suitable for low and medium-speed bearings, smooth. Will be partially immersed in the Groove in the stainless steel bearings, bearings for smooth by rotating parts, then flow back to the oil tank oil level should be slightly below the center of the lowest rolling element.
Smooth smooth oil suitable for the need to ration oil drops bearing components, suitable drip one drop every 3-8 seconds, too much oil will cause increased bearing temperature.
Oil pump oil sent to the bearing part of the filter, by bearing smooth oil filter again after cool down before use. Recycle oil can take the heat, cool the FAG bearing, therefore law useful for high speed bearing parts.
Dry shrinkage caused by air through sprayer mixed with varnish for oil mist, radiation-exposed bearings, the air flow can effectively cool the bearing and prevent intrusion. This method suitable for high-speed, low-temperature bearing part is smooth.
Pump nozzle into low pressure oil bearing, injection oil flows on the other side of the bearing in the bearing oil Groove. FAG bearings when spinning, rolling and maintained also with commensurate high rotary speed causes air to ambient air, smooth hard varnish to individual bearings when necessary using low emission of varnish spray to the stainless steel bearings, nozzle position should be placed between the inner ring and the maintenance of the Central.



Other News:
Review of FAG stainless steel bearing lubrication methods and principle of operation
Materials for rolling bearings temperature causes
SKF Bearing a simple measurement error
FAG spindle bearing Assembly how it affects their life
Bearing steel ball manufacturing processes
Centripetal ball bearing
FAG detailed Dental drill bearing four removal considerations
Maintenance of pumps of SKF bearings