1) In addition to the spindle bearings wick lubrication, and the rest are gear splash law and reciprocating pump lubrication. Box should have sufficient lubricating oil, the oil surface should be up to the oil surface instructions signage Office. The oil change period is generally three months. Oil change, you should first clean the box, and then refuel.
(2) hanging the institutions of the round of inside the box the main yes the carried out lubrication rely on the the gear splash oil Legalist. The level of the oil surface can be observed through the oil standard hole. The oil of the same every three months.
(3) the bearings and gears of the walk the knife inside the box, in addition to outside the the carried out lubrication to use the the gear splash oil Legalist,, but also by going along the oil storage tank is of the the upper part of the cutter box can, to carried out lubrication passes through the oil rope. Therefore, in addition to the need to pay attention to take the knife box oil standard hole high and low oil level in each class but also to take the oil storage tank for the upper part of the cutter box right amount of grease once.
(4) of the extension unit, the box set of the worm and worm gear, variable speed through the agency, the agency is to lubricate with oil inside the oil from the flange on the hole injection, injection into the hole below the edge so far. Other agencies inside the extension units, with the rope of the upper part of the oil storage tank oil lubrication. Usually each class fuel.
(5) extension units and turret in part by the hole for lubrication. Tailstock spindle, screw and bearing depend on the hole lubrication, screw, light bar and switch rod bearing lubrication rely hole 2,3,7. Each class refueling.
Oil cup of the lubrication of gear box bearings and lubrication plate box to change the gear oil cup 4,5, every 5 days plus 3 calcium-based industrial grease once.
(6), the guide face and carriage guide surface and the screw of the lathe bed in a comprehensive lubrication of the No. 40 machine oil should be used for each class before starting work and after work.
Other News:
Lubrication and maintenance of the basic things of the daily production on the l
Sand steel construction steel market continued to fall, or continue down to the
Automobile Association opposed the purchase of said crime against the wind of th
The steel trade and industry: to enhance industry credibility to reduce transact
Automotive NTN Bearing installation, use and maintenance of common sense
NSK Bearings vibration factors
What are the hot and cold shock chamber installation risks
TIMKEN bearing failure on the transmission
