IKO bearing can usually installation space is limited. In most cases, bearing is based on the mechanical design or other design limitations. Bearing type and size, thrust Angle contact ball bearing. What type of bearing seal? . So in the New Territories north total area choose the diameter of the decision is based on bearing. Therefore, the standard circular cone roller bearings are the main dimensions of the table according to international standards of the diameter size.

IKO bearing the service life of influence factors may have a lot of, can from the use of factors and internal factors to further instructions.
Use factor is mainly refers to installation and adjustment, and use the maintenance, the maintenance and repair, etc is in accordance with the technical requirements. IKO bearing according to installation, operation and maintenance, the maintenance requirements, on operation of circular cone roller bearings are under load, speed, working temperature, vibration and noise and lubrication condition monitoring and inspection, abnormal immediately find reason and adjustment, make it back to normal.
 
Installation conditions is one of the important factors to use factors, bearing for installation does not appropriate and often lead to a complete set of bearing the parts of the state change between stress, bearing in a normal state not work and end the using life.

To make IKO bearing and give full play to keep for a long time their due performance, must to do a preventive maintenance (check). Through the proper regular inspection, do it early found fault, prevent accident cure, to improve productivity and efficiency is very important.

1, cleaning

Will IKO bearing dismantling the inspection, use first photography and other methods do appearance record. In addition, to make sure the amount of residual lubricant and lubricant sampling, and then clean tapered roller bearings.

A, bearing washing and cleaning points thick fine cleaning, and can be used in the bottom of the container put metal grids.

B, crude washing, used in oil, grease or brush clear sticky content. If this time in oil turn IKO bearing, pay attention to other foreign material, damage from rolling face.

C, fine cleaning, in oil slowly rotating IKO bearing, must be carefully.
Usually used for neutral detergent no water diesel or kerosene, according to need to sometimes use temperature of the lye, etc. No matter use which kinds of cleaning agents, want to often filtering keeps clean. After cleaning, immediately in the circular cone roller bearings on oily-type rust coating or fat.

2, check and judging

In order to remove the judge IKO bearing whether to use, emphasize the check the size accuracy, the rotation precision, internal clearance and cooperate with noodles, groove surface, keep frame and sealing ring, etc. About the examination results, can be used to bearing or proficient in circular cone roller bearings on the judgment. The judgment standard according to the mechanical properties and the importance and inspection period and so on and different. If has the following injury, IKO bearing shall not to use, must be replaced.

A, bearing parts of the fracture and defects.

B, rolling road face the things rolling detachment.

Bearing manufacturing to want to pass commonly forging, heat treatment, turning, grinding and assembly process of multi-channel processing operations. The processing technology of rationality, advanced, stability will also affect the life of the bearing. Which affect the quality of the finished product tapered roller bearing grinding heat treatment and process, often and bearing failure has a more direct relationship. In recent years on the bearing surface metamorphic layer of work study, grinding technology and bearing surface quality closely.
IKO bearings use the main task of the life analysis, is based on a lot of background materials, analyze data and failure forms, and find out the cause of the failure of bearing the main factors that have targeted and put forward the improvement measures, extended circular cone roller bearings duty reduced, avoid sudden early failure of bearing happen.




Other News:
Avoid IKO taper roller bearings use a shortened life span of the maintenance met
IKO bearing manufacturing process deep grinding method
How to IKO bearing maintenance cleaning
FAG gyroscope gimbal bearings of regular inspection method
The process of cylindrical roller
NSK bearing greases the importance of stability
FAG needle bearing, anti-rust and maintenance method
Precision positioning table TU is introduced