1. Unscrew the fixed housing bolt. IKO will import bearings along with housing unloaded from the shaft together. Note in the open end of the shaft bearing IKO import before. Should the other end of the shaft bearing loosen bolts I, lest IKO ends import bearings with each other and don't damage.

2. Use first hex wrench, loosen IKO import bearing on the eccentric set screw, then use small iron stick into the sink eccentric set that hole, against the axis of rotation direction play loose eccentric sets.

A lot of people in the installation of bearing improper use of the installation method that causes the IKO import bearings damage. So how to correct installation IKO import bearings? Hope everyone more comprehensive understanding IKO import bearings installation and remove the:

For the imported bearing clearance fit IKO circle, the proposal is in besmear face with a thin layer of the peristalsis mordants, in case with surface friction corrosion.
390000 the spherical bearing is through series of eccentric shaft bearings are inner circle is fixed, the eccentric set of the hex screws up tighten role. In maintenance, many JiShou not dissect the IKO import bearings, it is necessary to introduce disassembling the 390000 series spherical IKO import bearings technical and points for attention:
The correct installation, for the use of import bearings IKO it is very important. Hope everyone can in the later use of using the correct installation method.

When installed, and may, according to their types and sizes, choose mechanical, heating or hydraulic method, etc. When installation to import bearings of the force applied IKO, must not be through the rolling body from a transfer to another bearing circle a circle IKO import bearings, otherwise it may cause damage to groove. But in any case, all can't direct bearing circle, maintains a knock, rolling body or the seal.
installation

3. Put eccentric sets. First the eccentric set set in IKO within the eccentricity of the set of imported bearing on the steps, and, along with the hand the axis of rotation direction on tight. And then the small iron bars insert or against the sink holes on eccentric set. With the hammer the axis of rotation direction striking the small iron. Make eccentric installed firmly set, finally lock on the set of the eccentric hex screws.

4. Fixed IKO import of the bearing first do not tighten bolts, and let the bearing in import bearing IKO coat can turn. Then the bearing bolts. The same pack good the same shaft on the other end of the bearing and the seat, will axis rotation several times, let IKO import bearing itself to be automatic find is after the position.

5. In housing and bearing with grease the surface, the import bearing load bearing IKO inside. Then will assemble good IKO IKO import bearings and import bearing on the shaft of together. Pushed to the desired location place for installation.

6. To shaft installed IKO before import bearings, / must first pulled out IKO import bearings coat fixed pin, and at the same time will shaft neck surface grinding smooth clean, and in the shaft neck place with oil and lubrication rust (allow bearing on the shaft has slight rotatio。




Other News:
The installation of the German FAG bearing whether it is right to affect the per
IKO import bearing disassembling skills
TIMKEN import bearings after installation should be paid attention to the inspec
Japan NSK bearing before installation to prepare
FAG miniature bearing installation indirect influence the cause of the service l
NSK bearings imported before installation of inspection
Remove the vibrating import bearings SKF method
One-way bearing safeguard way quenching technology is introduced