The installation of import bearings TIMKEN
TIMKEN import bearings of the thorough and axis with the general for transition cooperate, a circle and TIMKEN import hole for the bearing with general clearance fit, so the TIMKEN import bearings is easy to install, two-way TIMKEN import bearing the axis of the focuser drawtube springs in shaft shall be fixed, in order to prevent the relative to the rotation axis.

TIMKEN import bearing installation method, usually is the axis rotation in the majority, so the inner circle of shaft for win with coordination,
 
TIMKEN import bearing outer ring and import bearings with room TIMKEN for clearance fit.

TIMKEN import bearings after installation inspection
Installation TIMKEN import bearings, should inspection shaft centerline of vertical shaft and circle of degrees. Method is to dial indicators fixed in box shell ends, the head of the table to touch in TIMKEN import bearings rolling way rotation axis circle above TIMKEN import bearings, observe the dial indicators pointer, if the pointer partial place, explain shaft centerline not vertical shaft and circle. Box shell hole is deeply, and also can use longer dial indicators head inspection.

TIMKEN import bearing installed correctly, it can automatically adapt to a circle of roller rolling, ensure roller and roll in circle way. If the outfit, TIMKEN not only import bearings didn't work properly, and the cooperation will face severe wear. Because a circle circle and shaft and the difference is not very obvious, assembly should take care all the more, do not make a mistake. In addition, TIMKEN import bearing a circle and TIMKEN import bearing hole between should be left 0.2-0.5 mm of clearance to compensate parts processing, installation is accurate errors when running TIMKEN in import bearings rings center migration, the clearance can ensure that its automatic adjustment, avoid touch friction, make its normal operation. Otherwise, will cause severe damage TIMKEN import bearings.




Other News:
TIMKEN import bearings after installation should be paid attention to the inspec
Japan NSK bearing before installation to prepare
NSK bearings imported before installation of inspection
Remove the vibrating import bearings SKF method
One-way bearing safeguard way quenching technology is introduced
The bank of Japan: continue easing ＂protect the economy＂
Maintenance and inspection NTN bearing a few notes
Steel heat treatment stress