1 site selection and installation requirements

Installation site should lathes, grinders and other machinery and equipment some distance apart. Sites should be cleaned regularly to keep dry and clean to prevent iron filings, sand, dust, moisture entering the bearing.

2 test bearing type, prepare installation tools

Test bearing type, size meets the installation requirements, and in accordance with the structural characteristics of the bearing and associated with the various components, select the best method of mounting, ready to install with tools and measuring tools. Installation of hand tools commonly used hammer, copper, sleeve, special plate, screw mosquito clamps, presses, etc., the amount of a venire caliper, micrometer, dial gauge and so on.

3 test the surface of the bearing assembly

Associated with the surface of the bearing assembly and the part surface, where bumps, rust layer, debris, sand, dust and dirt there, a bearing installation difficulties, resulting in incorrect positioning of the assembly; two of these attachments to form abrasive, easy to abrasions bearing surface, affecting the assembly quality. Therefore, the installation before the deal journal, bearing surface of the shell hole, shoulder end, and connecting parts such as bushings, gaskets, end caps, etc. with the surface, for detailed inspection. If corrosion layer, can be ground off file fine, fine emery cloth polish, but also to remove the bearing assembly on the part surface and connected fixtures.
 



Other News:
Preparation before install lathe bearings
Precision Linear Rolling Guide Features
Substandard products of rolling bearings ring remedial measures
Fasteners selected according to different characteristics
Supplement and replace the lubricant
The storage method of bearing
The hardness of the bolt fasteners
Thrust (orientation) bearing installation