FAG bearings use environment: according to site conditions and conditions of use and the environment used to select size, precision, combined with suitable bearing is a prerequisite to ensure that the bearing service life and reliability.
Part of plant used bearings applied to accommodate radial loads in the radial and axial combined loading, usually with two sets of paired bearings use, mainly in the automotive front and rear wheels, active, differential bevel gear, gear reducer, transmission parts.
Allowed speed: installed properly, lubrication good environment that allows FAG bearing limit speed of 0.3-0.5 times times. Under normal circumstances, to 0.2 times the speed limit of the most desirable.
Allow the tilt angle: bearings are generally relatively tilt the housing bore axis is not allowed, such as tilt, maximum of 2 '.
Allowable temperature: under normal load, and with high temperature performance of lubricants and lubrication under adequate conditions, FAG bearings in general allow at-30 degrees centigrade-150 ℃ ambient temperature.
How to guarantee that normal FAG bearings during the application process, how to make bearings without injury to make longer bearing life.
1, selection and control of shaft and housing tolerances: bearing pressed into the bearing should rotate flexible no block. If there are clearly not flexible rotation, then axis dimensions are too big, the tolerance to cut.
2, bearing Assembly methods: FAG bearings are high-precision products, such as improper Assembly can easily cause damage to the bearing Raceway, cause damage to the bearing.
3, assembling foreign object prevention: FAG bearing when mounted to the rotor dynamic balance easily produced when iron filings into the bearing internal dynamic balance, so it's best to load bearing dynamic balancing before.
4 Prevention of rust, paint: paint and rust is characterized by multiple sealed-type motor, motor Assembly, sounds very good, but after some time within the warehouse, the electrical noise change very large, with serious rust removed bearing phenomenon.
FAG bearings in the process of checking in, if there are too many problems, as well as these bearings are bearings can be faked. That reminded everyone to use caution when selecting carefully.



Other News:
Clearance structure on TIMKEN bearings are major causes of Burns
Powder mixing equipment FAG bearing lubrication technique solution of Raceway noise analysis
Environmental considerations on impact strength of the use of FAG bearings
Proper use of NSK bearings need to pay attention to what issues
Several points to note the correct installation of NSK bearings knowledge elements
Judging dairy equipment failures in the NSK bearing used in maintenance method
Vibration and temperature for TIMKEN bearings damage prevention methods
FAG bearing several point inspection