1, selection and control of shaft and housing tolerances: NSK bearings pressed into the bearing should rotate flexible no block. If there are clearly not flexible rotation, then axis dimensions are too big, the tolerance to cut. If the bearing onto the shaft by hand after turning there is a clear "rustle" sense, the tolerances of the shaft may be too large or the roundness of the shaft well. So when you control the shaft and housing tolerances you want to control the roundness, many domestic manufacturers currently control only tolerance, not to control the roundness.
2, bearing Assembly methods: NSK bearings are high-precision products, such as improper Assembly can easily cause damage to the bearing Raceway, cause damage to the bearing. NSK bearing Assembly should have dedicated mold, cannot be beat at will, force in pressing axis only small circles, pressing circle only large ring bearing. Assembly call for pneumatic or hydraulic, at the time of pressing die outside to level up or down status, such as tilt can cause mechanical damage of bearing Raceway and the bearing rings.
3, assembling foreign object prevention: NSK bearing when mounted to the rotor dynamic balance easily produced when iron filings into the bearing internal dynamic balance, so it's best to load bearing dynamic balancing before. Some manufacturers for ease of Assembly, Assembly in the bearing room painted with some oil or grease lubrication effects, but in many cases the operator is difficult to control, indoor accumulates more if oil or grease in the bearings, NSK bearings easily along the axis of rotation into the bearing. Bearing room it is best not to paint oil or grease, such as non-coating is not available to control shall not be bearing Interior accumulates.
4 Prevention of rust, paint: paint and rust is characterized by multiple sealed-type motor, motor Assembly, sounds very good, but after some time within the warehouse, the electrical noise change very large, with serious rust removed NSK bearings. Many manufacturers are considered to be before bearing problems, through our advocacy, motor factory is now aware of the main insulation paint problems. Varnishes used for this issue mainly because of volatile acids under certain temperature, humidity of the formation of corrosive substances, corrosion and cause damage to the bearing Raceway NSK bearings. The problem can only be good choice of insulating varnish, and assembled in the ventilation after drying after a period of time.
NSK bearing life is closely related to the manufacture, Assembly, use, must be doing at each of the sessions to make bearings in top running condition, thus extending the life of NSK bearings.

 


Other News:
NSK bearing considerations should be used
TIMKEN bearing lubrication at low humidity corrosion is very slow
How to properly install a fag bearing failure problem
TIMKEN bearing static balance and homeostasis of choice
INA bearing on the use of environmental requirements
Analysis on performance of NSK bearing lubrication method
TIMKEN bearings creak control method
Analysis of life cycle maintenance of INA bearing