How much oil when oil change and should change. If oil is too little bearing on early retirement; if too much oil, bearings are in trouble or long-term danger to power coil and cable.
Lubrication interval has a simple premise: collapse of the bearing not dry and ceased to function under the conditions of maintaining the proper functioning of the device. This is a fixed concept of prevention. However, we must maintain a balance between excessive lubrication of lubrication-hungry and a lot.
After purging old engine oil, the oil lubricated bearings, if possible, should be poured into the fresh oil and let the machine at low speed of rotation for a few minutes. Oil collecting residue as possible contaminants, and then purging these oils. Note: engine oil is best to filter before use.
Use grease lubricated bearings when replacing the grease, used by Joe in addition should avoid contact with cotton to any parts of the bearing. Fiber because these residues may wedge between rolling and cause damage, especially small bearing application should pay attention to this issue.
When you check the bearings, don't let the bearing environment exposed to contaminants or moisture. If the work is broken, paper plastics or similar materials covering machine.


Other News:
Issues related to checking method for the bearing
Prolonged bearing life
Bearing on the basic requirements for using environment
Bearing axial vibration causes
Bearing process burns
Note extended bearing life cycle
Improved bearing life of five improvement measures
Bearing abrasion damage check