Three fatal noise of FAG bearing are: sound of impact rolling bearing raceways and the creak of the bearing. We regularly check the FAG bearings noise in order to find problems in a timely manner to solve the problem, so as to prolong the life of FAG bearings. Now to share my experience with everyone that the three ways to check the noise.
(1) the sound of impact rolling and its control method
Larger type ball bearings or cylindrical roller bearing under purely radial load at low speed operation, smaller due to the centrifugal force of the rolling, load-free area in the roll cage of rolling elements will shocks or road noise. But as the speed increases, this noise will disappear. On the rolling control method of pulse sound: appropriate reduction of radial clearance, reasonable structure and material compliance cage bearings.
(2) the roller bearing and its control method
Raceway is when a running FAG bearings, rolling the rolling body Raceway surface and a slippery continuous noise, occurs is all rolling bearing-specific basic sound. General bearing rolling road sound with other sounds. Ball bearing roller is irregular, frequencies in the above 1000Hz, the frequency of rate changes with the speed, but the total sound pressure level increases with the acceleration of the speed of. Roller bearings, its acoustic sound pressure level of the Raceway with the increase and decrease of viscosity and roller bearings of the smaller, its sound pressure level in the viscosity increases to about 20mm2/s above, from reduction to increase. Greater the rigidity of bearing, roller lower the total sound pressure level sound. Radial clearance is too small, Raceway total sound pressure level and frequency of the sound will surge as the reduction in radial internal clearance. Control method of Raceway: Optional low noise bearings FAG bearing corrugated-small, carefully selected conditions of use. Acoustic noise affecting the entire machinery of the Raceway, Raceway reduction can reduce the noise of the machinery as a whole.
(3) the creak of the bearing and its control method
Creak was cylindrical roller bearings on all occasions the possibility of harsh metal sound, mostly in the larger models of grease lubrication bearings, more deterioration of the base oil grease, oil hardly occurs. In addition, more prone to occur during the winter months, when subjected to a purely radial load, and susceptible to radial clearance, and with models of different sizes, occur at a specific speed range easily, both continuous and intermittent. External ring road, take the special processing methods can prevent the emergence of creak, if necessary, select the bearing, or reduce the FAG bearing radial clearance, using high performance grease and parts to match increasing bearing rigidity.
By checking the noise above these three methods, you can solve and prevent the occurrence of noise, thus prolonging the service life of the bearing.



Other News:
Prevention of three fatal noise of FAG bearings
Principles relating to the repair of deep groove ball bearing mechanism and method
TIMKEN stainless steel bearing installation operation and maintenance measures
Selection of FAG bearings failure caused by improper
Thrust ball bearings axial positioning of heating devices and
Analysis of causes and preventive measures of angular contact ball bearings burned
Rolling bearing normal cleaning process
Tapered roller bearing quenching medium and the choice of cooling agent requirements