Bearing maintenance techniques for complex problems are two: When oil and how much oil should be changed. If too little oil, the bearings will be early retirement; if too much oil, the bearings will be in trouble or long-term harm power coil and wire.
Traditionally, lubrication program is based on the time given. Equipment suppliers often lubricated according to the operation time to develop plans. Also, equipment suppliers in the course of their regular maintenance program for the amount of oil added guidance. For the staff, the short-term replacement of oil is a very common thing, and is often added grease ones. If officers are required every two to three weeks to replace oil, every time you add an ounce of grease. These recommendations led to the outset that they are no practical significance in some unknown factors of the set up.
Lubrication intervals have a simple premise: the bearing does not collapse due to dry and stop the conditions to maintain a reasonable device operation. This is a fixed concept of prevention. However, we must maintain a large number of excessive thirst and lubrication lubrication balance.



Other News:
Bearing operation to when the oil
Factors affecting friction factor
Introduction The importance of bearing lubrication
The fatigue strength of rolling bearings
Operation when the rolling bearings oil change
Effect of bearing lubrication and lubrication on the importance of introducing
Bearing damage and precautions 4 points
Small Rolling causes and prevention of corrosion