Tribune Chronicle reported that US Department of Labor's Occupational Safety and Health Administration cited Timken Co on 12 alleged safety violations, including five repeat, after an inspection in June at the Canton steel mill.

The Labor Department said that proposed penalties for the mill that manufactures roller bearings could total USD 170,500.

Five repeat safety violations involve failing to machine guard ingoing nip points, points of operation and rotating parts. Additionally, the company lacked guardrails on elevated platforms and failed to ensure electrical boxes with unused openings were closed.

Seven serious safety violations involve failing to reduce compressed air for cleaning to 30 pounds per square inch or below; maintain floors in dry condition; conduct annual training for workers designated to use portable fire extinguishers; provide an emergency eyewashing station; ensure each authorized worker affixed a personal lockout device to a group lock box to prevent the unintentional release of hazardous energy; and properly adjust machine guarding. A serious violation occurs when there is substantial probability that death or serious physical harm could result from a hazard about which the employer knew or should have known.

About 300 workers are employed at the Canton facility; corporate-wide the company operates in 30 countries and employs about 21,000 workers.

Other News:
Federal agency fines Timken Co
FAG Top-Laser EQUILIGN – a new alignment that pays its way
Rod end bearing can handle higher tensile loads
RKB Group Introduces New article on bearing optimization via evolutionary algorithms
NTN Developed “Motorized Linear Module for Tracking System of Solar Heat/Solar Light Power Generation”
Crank-based gearbox in development
US raw steel production gets a 3% boost after holiday
ABB acquires Gresin to expand press automation solutions