Different standard of judgment based on the mechanical properties and the degree of importance and inspection cycle. Injury, subject to the following one-way thrust ball bearings can not re-use, and must be replaced. In the process of using a bearing, the grease is very critical. If use of the deterioration of the grease, not only to achieve its proper role, away also damage the bearings.
Lubricants will twist between the thumb and index finger repeatedly grinding the the lubricants hands feel better lubricity, less wear debris, friction-free, if they feel the sand between the fingers like a larger friction sense indicates that the lubricant impurities within can not be reused, should be replaced with new oil.
Way thrust ball bearing raceway raceway sound control sound when the operation of the one-way bearing, rolling element raceway scroll issued a slippery continuous sound, a unique all Rolling occur The basic sound. The general sound of the bearing raceway sound and other sound. The ball bearing raceway sound is irregular, the frequency of 1000Hz or more, its main frequency does not change with the speed, but the total sound pressure level increases with engine speed to accelerate.
Roller Daosheng large bearing raceway sound SPL is reduced with the increase in viscosity; small bearing raceway sound, the level in the viscosity is increased to more than about 20mm2 / s, by reducing transfer is somewhat increased. The greater the rigidity of the bearing raceway sound overall sound pressure level is lower. Such as the radial clearance is too small, the total sound pressure level and the main raceway sound frequency will be increased dramatically with the reduction of the radial clearance. Control raceway sound: the selection of low-noise bearing waviness small bearings, carefully selected conditions of use. The raceways sound often affect the mechanical noise to reduce the raceways sound can reduce the noise of the machinery.
The one-way thrust ball bearings metallurgical quality of the materials used to affect the main factors of premature bearing failure. Followed by metallurgical technologies (such as bearing steel vacuum degassing, etc.) to improve the quality of the raw materials to be improved. The proportion of the raw material quality factors in bearing failure analysis has decreased significantly, but it is still one of the main factors bearing failure. The selection is properly still bearing failure analysis of the factors that must be considered.
The main task of the one-way thrust ball bearing failure analysis, is based on a lot of background material, analysis of data, and failure modes to identify the main factors causing bearing failure, so that targeted improvement measures are proposed to extend the service of self-aligning roller bearings period, to avoid bearing the unexpected early failure.
Other News:
The United States found that the nearest star is so far away from the center of
Way thrust ball bearings noise generation and Remedy
The report of the United States pro-US enterprises do not do business with China
Nepal plane crash victims compatriots funeral held in Nepal
Day said the Chinese official boat consecutive 9 days into the waters of the Dia
This support rate advantage will elect a new President Hugo Chavez in Venezuela
Indian media said the enterprises to obtain construction contracts bribery Nepal
Foreign media attention to the US suppress Huawei, ZTE said China ＂worried＂
