Japan NTN Corporation (NTN) successfully developed a condition monitoring system (CMS), to real-time monitor blades (the blades of the windmill) and spindle constitute the engine of the various parts of the state. The system was developed using the training in the main product bearing diagnostic techniques, measurement by the industry's smallest levels of data collection devices and monitoring software, sensors, and data management software component.

NTN in the fall of 2012 began to supply samples to offshore windmills and onshore windmill is expected to also be effectively used such as tidal power generation mode. Although the price has not been announced, but set at the same level, and other company's products.

It is understood that incorporated wind turbine spindle, multiple measurement sensors and 250 mm × 290 mm ??× 108 mm, data collection devices installed within the casing of the servo amplifier and generator. Data management software can automatically monitor leaves, shells, etc. vibrational state and the spindle, servo amplifier, generator bearings and gears with or without injury.



Other News:
Japan NTN developed a small remote monitoring system
SKF cooperation with Tongji University through the technical knowledge training
SKF bearings of low-noise installation and adjustment method
Steel City will continue to weaken or lower than the low for the year
Steel overcapacity exacerbated by interest rate cuts short-term is difficult to
Domestic economic impact of the first half of Xiangyang bearing net loss of abou
INA cylindrical bore bearing installation method
Infrastructure projects downturn machinery enterprise funds of the pressure of t