SKF bearing in the plan is best lubricating equipment during the stop, and regularly for supplement, at the same time, the old oil remove or through oil free relief will be old oil out. Add the fresh oil in before will note nozzle should be wiped clean. If SKF bearing bearing box no note nozzle, should be open bearing box or cover, to take out the old oil, to clean up after the same type of fresh oil added.
In order to guarantee the normal operation of SKF bearing, we need to periodically to check the oil and oil level of the oily, usually, normal oil level should be a window or mark oil equipment of a third-two-thirds range. Oil compensating for the way oil cup, the display of oil to represent only a fill oil ability, and bearing a box of oil is to satisfy the requirements of the operation, a less than its Chinese oil cup a quarter of the total volume can consider to fill oil.
Check and fill oil method is, take out a small amount of oil as samples and fresh oil comparison, the ability of the unit may be considered for oily test, to ensure the oily qualified. If the sample seemingly nebulee , then may be the result of the mixed with water, which you can often say oil emulsion, this time should change lubricating oil. If the sample is dark color process or change in the thick, then may say oil has started carbonation, should the old oil thoroughly change. If possible, use fresh oil to fuel to wash. Oil changing when, should make sure the replacement of the old and new oil identical model, and meet the requirements of the supplement of the oil level.
Use oil bath type lubrication system, if the oil temperature in the 60 ℃ (140 ° F) the following, and oil is intact, the replacement of a lubricating oil in a can. If the oil temperature in 60-100 ℃ (140-210 ° F), is a year need to replace four lubricating oil. If the oil temperature in the 100-120 ℃ (210-250 ° F), the need to change a lubricating oil per month. If the oil temperature in 120 ℃ (250 ° F) above, the weekly need to replace a lubricating oil.
The correct installation and maintenance is bearing the normal operation of the important factors, meanwhile, must pay attention to maintain the purity of the bearing. Bearing must protect from pollutants and moisture pollution, must have the correct installation and lubrication. In addition, bearing with the design of the listed the condition,, oil seal lubricants and forms of change cycle and special maintenance also played an important role, must pay attention on them.
Other News:
Steel raw material market stability weak at entrance mine fell
SKF lubricated bearing the methods and ways to maintain introduction
Clutch release bearing the cause of damage
FAG tapered roller bearing operation appears in the abnormal analysis
Banking regulatory commission warning bank: To steel trading enterprise should l
Property market is heating up for better meet just to relax on behalf of regulat
Network room ＂false propaganda jie developers seven big profits law
Industry general kui steel boss where to go?
