First, at the connection of various components of good scale, and then open a wheel system of the machine tool subsystems wheel dressing system guide wheel system guide wheel dressing system hydraulic system lubrication systems, fittings and bolts of the various components, please classification placed so as not to confuse or lost.

Second, Check the outside diameter of the wheel spindle is not 75MM, if the small over five wire, it is recommended to change the axis, do a 75MM 10 wire pig iron grinding stick with research bearing until all come into contact with the assembly to do a hole 75 is 2 wifehood 110 of negative 2-wire concentric sets of concentric sets to adjust the machine tool spindle and the machine shell concentric, but also to ensure that the spindle horizontal clearance shall not be greater than 0.01MM wheel shaft by hand can easily rotate.

Third, check the dresser and the cylinder was torn off and hands to pull the trimmer back and forth freely, shall not have the severity; hand from side to side without gaps, not with scraping.

Forth, check the wheel the same deal with the guide wheel shaft and bearing, and then concentric sets of adjusting the machine tool guide shaft to ensure no axial transmission axis horizontal gap within 0.002mm. No unusual noise after driving

Fifth，Because MG1020 with hydraulic self-lubricating rail hydraulic system must be completely removable and washable, re-regulator pressure size, please refer to the instructions. "

Sixth，Lubrication system is to protect the wheel axis is like the heart of protecting the brain is particularly important to the system removable and washable installed, 2 to connect the wheel to try to cut off oil to the machine is not guard.

Seventh, the guide wheel dresser debugging methods and wheel.