Bearing in the grinding process, the surface of their work is carried out by high-speed rotation of the grinding wheel,  so if you do not operate according to operating instructions and adjust the equipment, it will appear in the bearing surface flaws, which affect the overall quality of the bearing. Bearing in precision grinding, due to rough demanding surface grinding work can often trace to the naked eye the surface grinding marks are the following.

Performance of cross spiral traces

When this was mainly due to traces of grinding wheel of the bus straight poor, there is bump phenomenon in grinding, the grinding wheel and work piece is only part of the contact, when the work piece or the grinding wheel several times from the movement, the performance will be reproduced in the work piece cross-helix and the naked eye can be observed. The helix pitch and the work piece table speed, the size of the work piece speed, but also with wheel axis is not parallel to the rail line and the table.

(A) the main reason for the formation of spiral

1 Dressing bad, not chamfered corners, are not used for repair coolant;

2 table guide rails too much oil, resulting in floating table;

3 machine precision is not good;

4 grinding pressure too large.




Other News:
Bearing in grinding
The power of the motor speed control principle
Choose a good precision of reasonable structure cage bearings
Three types of methods to check the bearing clearance
Bearing outer ring fixed method
How to use method checks rolling bearings
Bearing crack processing and acceptance criteria
Add the amount of rolling bearing grease