Loss of IKO bearings for many reasons, all design and manufacturing process factors and bearing the loss related to analysis of them difficult to judge. Under normal circumstances, in general it can be considered from the use of factors and internal factors and analysis.
The loss of cylindrical roller bearings use factor refers to the installation and adjustment, use and maintenance, such as maintenance and repair to meet the technical requirements. Installation conditions is the primary factor in the use of factors, one of the IKO bearings tend to lead to state changes between the entire bearing various parts due to the installation of inappropriate operation and loss of bearings in the normal state. Bearing installation, use, maintenance, maintenance, technical requirements, bear on the operation of the bearing load, speed, operating temperature, vibration, noise and lubrication condition monitoring and inspection, abnormal immediately find reasons to adjust to back to normal. In addition, the grease quality and the surrounding media and the atmosphere is also very important to carry out analytical testing.
Local damage due to the operation or installation errors, the small part of the bearing raceway and rolling element may be damaged. IKO bearings in operation, roll over the damaged parts will have the specific vibration frequency. Frequency analysis identifies the damaged bearing components. The vibration behavior of applications in many applications, the cylindrical roller bearing is stiffness and the stiffness of the structure around the same. This feature to correctly select the bearings (including pre-load and clearance) and its configuration in the application, it is possible to reduce vibration applications.
(1) Friction compatibility
    direct contact with the bearing shaft diameter and bearing to avoid the onset of adhesion and form the border smooth performance. Affect the Friction compatibility information elements are:
    (1) into the difficulty level of the deputy information metallurgy constitute alloy.
    (2) Information and Glazes affinity and talent.
    (3) Into the vice information in the absence of the friction factor in the smooth state.
    (4) The microstructure of the information.
    (5) Information on the thermal conductivity.
    (6) Information on the appearance of the size and the oxide film characteristics.
     (2) Clamp
     Information to allow foreign hard particles clamp Glazes into to avoid scratching or (and) the abrasive wear of the can. Metal data, the low hardness and elastic modulus of the lower clamp into just and nonmetal information is not necessarily, for example, carbon graphite, lower modulus of elasticity, but the clamp into the bad. Cylindrical roller bearings are usually relatively soft data and hard data constitute a friction increase, ordinary use softer information does bush.



Other News:
IKO cylindrical roller bearings heat to produce the main reason analysis
How to seal angular contact ball NSK bearings
The basic properties of the thrust-aligning roller
Note of using TIMKEN deep groove ball bearings
Electrical insulation bearing the classification and size range
Rolling bearing lubrication should follow the principle
Characteristics and classification of the deep groove ball bearings
Conventional martensite quenching and organization and performance