INA the decentralized Bearings to settle due to inner and outer ring can be conveniently split mounted to the shaft or Bearings housing should attract detailed is already installed inner shaft insert is installed good outer ring of the Bearings box , even if its link mind, to prevent scratches to rotate the body and raceway. INA Bearings inner ring and shaft tight fit and non-slack Bearings outer ring of the Bearings hole is loose with safety suddenly,
Decentralized Bearings to settle due to inner and outer ring can be conveniently split mounted to the shaft or Bearings housing. Attention should be detailed and will be already installed inner shaft insert has been installed good outer ring of the Bearings box , although even their link concerted efforts to prevent abrasions to turn the body and raceway.
INA Bearings inner ring and shaft tight with lax type Bearings outer ring of the Bearings hole is loose with safety suddenly, the available press the Bearings first settled in the shaft, then the axis together with the Bearings installed all the way to the Bearings holes, if Bearings small, can also be used relatively soft metal hammer tap the ferrule end face to force the Bearings to as percussion force must be evenly diffuse derivative Bearings rings.
The Bearings outer ring and the Bearings hole for a tight fit to the inner ring and shaft loose with seasonal, can Bearings the first installed in the shaft.
INA Bearings ring and shaft or the Bearings hole is tight with seasonal settle sets of barrels at the same time apply a special Bearings pressure to the shaft or Bearings housing.
When INA Bearings size than the large, the interference with the required settle power compared to large, or suffer a heavy-duty things Bearings large and therefore accepted by the cold state to settle hard, you need to pre-Bearings inner race or Bearings Block heating and then settle. Suddenly in the hot state security, the heating temperature should be harsh restraint. Heating Bearings, the maximum heating temperature does not cross 1200C, the same unusual should of 80 ~~ 1000C. With a dust cover or seal the Bearings can not be heated, otherwise it will cause the loss of lubricant flow. The style of heating can be accepted by induction Beauty, heating oil bath style.


Other News:
INA Bearings Installation of cylindrical bore Bearings
INA Bearings failure of treatment and necessary maintenance measures
TIMKEN bearings contact fatigue failure of the adjustment method
SKF bearings on a regular basis to maintain the need for attention
Extend the service life of SKF bearings
FAG Bearings operation after installation check
Determine the use of FAG Bearings
NSK Bearings to judge the basic standard of repair