FAG bearings role is to make the geostationary ring and rotating ring of FAG bearings respectively and mount the static local (usually the FAG bearings) and rotating parts (usually the axis) with consolidation, thus achieving transmit loads and qualify in a rotating motion system relative to the stationary system of basic tasks. In the shaft and FAG bearings, rolling bearing requirements in a radial, axial and tangential direction three fixed its position. Radial and tangential orientation achieved through a tight fit to the FAG bearing mining, axial position only in a few cases the use of tight fit; General axial limited parts, such as the end cap and retaining ring to limit the axial position in the context of clearance.
When choosing a tie should focus on the following 4 points:
1, FAG bearing force uniform circumferential surface should have good support and, in order to reduce distortion and can take advantage of FAG bearings bearing capacity.
2, ring cannot slide along tangent directions in the suit looks, this may damage the mating surfaces.
3, required attention FAG bearing units and removal easier, expenditure when you cut corners.
4, the free end FAG bearings required and adapt to changes in the length of the shaft and housing bore, that is required to adapt the axial location in the ability to walk within a certain range.


Other News:
FAG bearing several problems should be paid attention
＂TIMKEN bearings should be replaced,＂ the judgement method
Too high temperature of TIMKEN bearings running inspection and operation problems of
FAG bearings finishing order of steps
INA bearings early damage caused for several reasons
NSK bearing corrosion control and elimination technology
How to reduce the effect of temperature and vibrations on the life of INA bearings
SKF bearings checking and acceptance should pay attention to what issues