TIMKEN bearings greases lubricate if available, are generally durable, but often TIMKEN bearing lubrication problem, not bad grease, is inappropriate method of lubrication, the final result was a TIMKEN bearing life is not long. Following are six lubrication method:
First, the mechanical stability; oil in machined will become soft, resulting in leaks. During normal operation, oils from within the housings and throw to the TIMKEN bearings. If the mechanical stability of the grease is insufficient, in operation, will make the structure of the SOAP oils mechanical disintegration, causing oil to be destroyed, and thus lose lubrication.
Second, you cannot mix fats; never grease mixed with incompatible, if two incompatible greases mixed use, its consistency is usually soft, will probably end TIMKEN bearing damage due to oil easy to drain.
Third, the oil seal to the rigorous; protection of TIMKEN bearings and lubricant oil seal is required from outside contamination barrier, bearing in operation, regardless of debris or moisture cannot penetrate the bearing, caused damage to its case.
IV, classification and selection of oils and fats; distinction based primarily on temperature and working conditions: fats and oils can be categorized according to their allowed working temperature to, the consistency of the grease and lubricating ability is affected by the temperature of, TIMKEN bearings operating at a temperature must be under the same temperature you want to select the correct consistency and good effect of lubrication oils and fats.
V, rust-proof performance; used in the TIMKEN bearing grease must have a rust-inhibiting effects, antirust preferably insoluble in water. Fats and oils should have good adhesion, and steel a layer of oil film formed on the surface.
VI, the viscosity of the grease; if the wrong choice grease TIMKEN bearings of all prevention measures are futile, select a grease, its base oil viscosity at the operating temperature is able to provide adequate lubrication of the effect is very important, viscosity, mainly under the influence of temperature, which decrease with the rise in temperature, it will rise when the temperature drops.


Other News:
Add grease method of extending service life of TIMKEN bearings
TIMKEN bearing installation scars is how to deal with
FAG heat treatment of bearing parts in three steps
INA bearing operation well so long life
Treatment method of high temperature injury using TIMKEN bearings
Analysis of TIMKEN bearings seal
INA bearings under conditions of high temperature grease
SKF bearing lubrication maintenance measures of industry introduction