TIMKEN bearings installation final clearance adjustments should be carried out. Clearance values should be used depending on the interference of condition and fits the size specified. If necessary, the test should be carried out.
Double row tapered roller bearings and water pump bearings good clearance has been adjusted at the factory, installation without adjustment.
After TIMKEN bearings, should check whether inner Raceway of rolling and flaking, excessively Yu Songkuang cage, inner ring around the edges are complete, crack on outer ring raceway. After the ring and roller Assembly mounted to the outer ring, roller roll should fall into the middle of the road, move does not exceed 1.5mm. Which have not qualified, that is, you cannot use.
In the case of less interference, can be pressed at room temperature with sleeve TIMKEN bearing ring face, using hammer tapping sleeves, rings balanced through the sleeve is pushed. If the mass installation, to be used in hydraulic presses. When pressed, should guarantee the outer ring side face and the shell shoulder end surface, inner ring and shaft shoulder end surface clamping, gaps are not allowed.
Such TIMKEN bearing outer rings are separable. Normal state, the inner and outer ring raceways and rollers should not be crushing, grinding deeper pits and mark; cage should be no deformation on the ring, and rollers can be full; inner and outer ring raceways and rollers clearance should not exceed 0.06mm.
TIMKEN bearing installation, you must exert equal pressure on the circumference of the ring face, ring is pushed, do not use tools such as hammer percussion bearing faces directly, in order to avoid damages TIMKEN bearings.
Other News:
INA bearing heat treatment hardness detection and classification
TIMKEN bearing installation should pay attention to when clearance adjustment
Teaches you to choose skills INA bearing grease
NSK bearing grease metamorphic testing methods
Identification of NSK bearings can be used
TIMKEN bearing technology improving the axial rigidity of bearing great
Of a material performance of FAG bearings
TIMKEN bearings and axial clearance must be suitable
