1. Keep the FAG bearings lubricated and clean.
Before checking the FAG bearings, FAG bearings surfaces should be clean, and then surrounding the demolition of FAG bearings parts. Here it is important to note that oil seal is very fragile parts, so check and FAG bearings to use excessive force when reassembled, so as not to cause damage to parts. If you check the FAG bearing oil seal and its surrounding parts have shown adverse symptoms, be sure to replace, so as to avoid the evils of oil seal causing the FAG bearing damage.
2. FAG bearing lubricant quality.
Many later found FAG bearing life is too short, found that among other factors, outside the normal, does not directly affect the quality of the known lubricants. On checking method for the FAG bearing lubricants for: stained lubricant on friction between two points, if the presence of pollutants, are feeling out; or coated with a thin layer of lubricant on the dorsum, and then make the rays. Then there is the replacement of FAG bearings lubricant. Note: oil'd filtered before use. The use of FAG bearings grease lubricated when replacing the grease, used by Joe in addition with cotton corners should be avoided to FAG bearing any of the parts. Fiber because these residues may be between wedge on scroll and causing damage, especially small bearing application of more attention to this issue.
3. FAG bearings work environment.
When checking the FAG bearings, don't let their exposure to contaminants or moisture environment. If the work is broken, should be oiled paper plastic or similar material of his machine. Bearing's working environment is also very important, many mechanical bearing because the work environment no, leading to FAG bearing life ended prematurely.
Other News:
FAG bearings maintenance considerations
Quality inspection of NSK bearing grease
NSK bearing radial location of choice
INA bearing installation and maintenance considerations
FAG bearings maintenance and solutions
TIMKEN bearing install operation check
FAG bearings for correct installation and adjustment method of low noise
TIMKEN bearings what are the common heating methods
