Small dust even eye can't see, will bring bad effect to the thrust ball bearings. So, you want to keep around clean, so that dust will not incursions into the bearing.
And the Timken bearings a strong impact in the use, will have scars and creasing and become the cause of the accident. Serious cases, cracks, breakage, so care must be taken.
To avoid the existing thrust ball bearings replaced, you must use the appropriate tool. We have often stressed the importance of tools, is because there are too many customers in the installation of bearing failures were caused by using the wrong tools.
On shafts and in housings, Timken bearings require radial, axial and tangential direction three fixed its position. Radial and tangential position through the tight fit of the thrust ball bearing production implementation, axial position only in a few cases the use of tight fit; General axial limited parts, such as the end cap and retaining ring to limit the axial position in the context of clearance.
Select the cooperation should focus on the following four points:
(1) the circumferential surface of bearing rings should have good support and force uniform, in order to reduce the distortion, and can take advantage of Timken bearing load capacity.
(2) the rings in its mating surfaces cannot slide along tangential direction, otherwise it will damage the mating surfaces.
(3) the free end bearing must be able to adapt to changes in the length of the shaft and housing bore, namely the need to adapt the axial location ability to walk within a certain range.
(4) care must be taken to enable the Timken bearing installation and removal easy, expenditure when you cut corners. When operating the thrust ball bearings, Khan will become the cause of rust on the hand. To note that the clean hands operation, it is best to wear gloves as much as possible.


Other News:
The thrust ball bearings Timken the light usage considerations
How to choose a self-aligning ball bearing and precautions in use
SKF bearing analysis on causes of premature aging
Deep groove ball bearings Timken maintenance best practices
Self-aligning roller bearing life cycle extension method
Analysis of FAG bearings cause of defects in surface grinding
INA self-aligning ball bearings axial clearance adjustments should be noted
Trajectory of the tapered roller bearing loads on the relationship between the