Because the FAG bearing types, structure, tolerances, technical requirements, and the quantity of material differences, the basic production processes vary greatly. Here's a brief introduction to the production process.
, Common FAG bearing parts processing:
1. FAG bearing of rings: FAG bearing within ring and outer ring of processing in accordance with raw materials or rough forms of different and vary, which car processing Qian of processes can is divided into following three species, entire processing process for: Rod material or tube material (some Rod material needed by forging and annealing, and are fire)--car processing--heat treatment--mill processing--lapping or polishing--parts end checked--rust--: ball of processing also according to raw materials of State different and vary, which contusion and cut or light ball Qian of processes, can is divided into following three species, heat treatment Qian of processes, also can is divided into following II species, entire processing process for: Rod material or wire, pressing Dise (some Rod material cold rushed Hou also needed rushed ring with and annealing)--contusion and cut, and rough mill, and sharpens or light ball--heat treatment--hard mill--fine mill--lapping or grinding--end checked group--rust, and packaging--reporting-as-finished straddling pending collection sets assembly 〉 key.
3. FAG bearing cages: FAG bearing cage design of machining process based on different structures and materials, can be divided into the following two categories:
(1) stamping sheet metal shear blanking → → → → shaping and finishing → pickling or shot or cross talk → check → antirust and packaging → library (to be assembled)
(2) during the processing of solid cage of FAG bearings: processing of solid cage, vary according to the different materials or rough, before they where processing can be divided into the following four types of rough type, the entire process:
Rod material, tubes, forgings, castings – inner diameter, outer diameter, face, chamfer – bored (or pull holes, boring)-pickling--checked – antirust and packaging – the storage trap Assembly.
Second, FAG bearing Assembly process:
FAG bearing parts such as the inner ring, outer ring, ball and cage, after inspection by, entering the Assembly workshop for Assembly, the process is as follows:
Demagnetization, washing → inner and outer ditch road roller size grouping sorting riveting → → → check clearance cage → check → demagnetization, washing → antirust and packaging-finished products.




Other News:
FAG bearings production process
TIMKEN bearing selected skill points and role
Contact SKF bearing caps placed in soft material seals
How to correct lubrication maintenance of SKF bearings
INA bearing replaced common methods
SKF bearing maintenance process under static pressure probe
Considerations should FAG bearings
Optimized TIMKEN bearing friction-resistant maintenance and lubrication