Bearing the name INA 23136CC/W33 bearing
New model 23136CC/W33
Older model 3,053,736
Diameter d (mm) 180
Outside diameter d (mm) 300
B thickness (mm) # 96
INA model 23136CC/W33
Bearing brand INA
Roller bearings with bearing type
Detailed descriptions of spherical roller bearings (20000CC/W33)
Notes
INA 23136CC/W33 bearing on:
INA bearing 23136CC/W33 brand: INA bearings, bearing type: spherical roller bearings, new model: 23136CC/W33, model: 3,053,736, diameter: 180 (mm), outer diameter: 300 (mm), thickness: 96 (mm), additional information: spherical roller bearings (20000CC/W33)
INA bearing seal purpose: prevents dust, moisture and impurities from entering the bearing, and also to prevent the loss of lubricant. Good seal guarantees that the machines work, reduce noise, and extend this part tho. -Contact seals and sealing way non-contacting seals.
1.-contact seals
Due to the seals in direct contact with axis, friction, wear and serious, practical only in low speed situations. -Contact seals are:
① felt ring seals
Open trapezoid Groove on the bearing caps, made of felt according to the standard ring or belt-shaped, placed in ladder-shaped Groove in the shaft tight fit contact, as shown in Figure 11-38. Felt ring seals used primarily for grease lubrication, the structure is simple, but the friction coefficient is large, only used for sliding speed is less than 4~5m/s, and where the operating temperature does not exceed 90 ℃.
② lip type seals seal
Bearing cap, place a lip seal rings made with oil-resistant rubber, lived on bend elastic force of the rubber ring and attach the spiral spring coil fastened and tight on the shaft, so that role. Lip type seal ring direction towards the sealed parts of the sealing lip. If are used primarily to seal oil, sealing lip of INA bearing (inner); if dipping is primarily to prevent foreign objects, the sealing lips should be facing away from the bearing (facing away from you, Figure 11-39); if two requirements are needed, it is best to use the sealing lip reverse placed two lip type seals. Lip-ring seals can be used for sliding contact surface speed is less than 10m/s (when the axle is fine) or less than 15m/s (when the journal was Polish) occasions.


Other News:
INA bearings 23136CC/W33 spherical roller bearings
FAG 2309K self-aligning ball bearings
TIMKEN bearings 2313K + H2313-aligning ball bearings
TIMKEN bearings 23134CCK/33+H3134 spherical roller bearings
NSK 23096CACK/W33+H3096 spherical roller bearings
NSK bearings 2313K-aligning ball bearings
NSK bearings 23134CCK/W33 spherical roller bearings
TIMKEN 23096CACK/W33 spherical roller bearings