In order to distinguish removing SKF bearings can be used to check after the bearings washed clean. Check Raceway, scroll, status of the mating surfaces, adhere to the wear condition, increased bearing clearance dimension precision landing and has nothing to do with injuries, the exception. Non-separation of small ball bearings, the inner ring with one hand the degree of support, rotating the outer ring to confirm whether fluently.
Bearing maintenance: cleaning of SKF bearing: bearing under removal maintenance, bearing the appearance of the first documented, confirmed the smooth residual stocks of agents, after sampling checks with a smoothing agent, washes the bearings. As a cleaning agent, general use gasoline, kerosene.
SKF bearing industries outside, it kind of grease to use maximum high speed wire rod rolling mill bearings, accounting for about sharing fat 70%. Because such grease selection of fibers, soft, light filtering white lithium thickener, use mineral oil as base oil, very light hard to know foot low quality SKF bearings reduce vibration value requirements. Another interest is no bad conscience of pump, whether it is mechanical fatliquoring remains hand-painted resin, are simple and difficult. And the low price of the grease, could significantly reduce the cost of bearing. However, due to the use of mineral oil, grease of the kind that are rust and rust on the function of some physical and chemical target large buckle. Bearing life can be up to 200 hours, linear Guide frequently asked questions. Starting and running torque is-20 degrees centigrade when tested without problems. The class grease temperature General-20~120℃, when used at high temperature is 150 degrees centigrade above, formed the essential oils evaporate too quickly and flow phenomena such as severe, greatly reducing SKF bearing life.
Currently, using increasingly fine fine bearing device, used for SKF bearing greases must free the following functions:
(1) No and SKF bearing the same operational life, try to delay maintenance cycles, reduced downtime, labor yield.
(2) the is DN>5x105 speed to assure low motor temperature rise, not oil, thereby reducing power consumption, asylum motor.
(3) its pure content moderation is necessary under the standards, maximum reduction of equipment noise pollution.
(4) are ultra-low temperature do assure SKF bearings provided start-up and operation of spirituality, bearing frequently asked questions. Assure minimum output power.
SKF bearings down cleaning, cleaning rough and fine cleaning, placed in a container, put the first metal mesh on the bottom, bearing no direct contact with the dirt of a container. Coarse cleaning, should rotate the SKF bearings with dirt, can damage the rolling surface of SKF bearings, you should take note of. In cleaning crude oil, use brush put to fat, smooth, stickers, after cleansing, sperm washing.



Other News:
Introduction of SKF bearing noise reduction to maintain lubrication method
How to check the TIMKEN bearings in operation
TIMKEN bearing handling force attention to essentials
INA bearing vibration in prevention work
TIMKEN bearing periodic lubrication and maintenance
TIMKEN bearing selection and methodology
TIMKEN bearings of rolling impact sound and its control method
Considerations for SKF bearings used in greases