The recent large factories to our consulting bearing should buy or repair is more cost-effective, INA Bearings mass production of mechanical parts, and manufacturing precision is very strict, and a high degree of technical specialization, so readily available for the vast majority of bearing varieties , buy than repair is more cost-effective, and only in the following cases, fix the problem before considering bearing, that
    1, bearing a slight injury, such as the inventory produced during the mild water rust, as well as minor fretting abrasion during transport, such cases repair and wasteful to discard.
    2, a lot of the same types of bearings used in large factories, the form of failure for the rolling surface wear, fatigue or micro-abrasion, damaged parts mostly cage or rolling elements, rings or gaskets still fix the value of ;
    3, large and extra large bearings, the brink of failure or failure Although and parts no significant damage, or precious bearings must try to extend its useful life
    4, some bearing varieties, is really difficult to buy into failure had to repair spare parts, especially the longer delivery time;
    In addition to the economic, TIMKEN bearings repair, as well as its technical which requires repairer fully understand bearing the corresponding technical requirements, bearings and parts thereof in the structure, process and material characteristics, it would be difficult to ensure that the bearing repair there are in line with the desired effect.


Other News:
Bearing repair reuse analysis
Bearing Ferrography
Bearing failure causes and preventive measures
The bearing noise generated by the analysis of the reasons
The fault maintenance measures analysis bearings run
Analysis of the gist of the rolling bearing assembly process
How Sounding detection oilless bearing damage
Note disassemble the bearing