Bearing is a major important components of industrial equipment. SKF bearing problems can result in costly downtime, equipment damage and failure. In addition, large industrial SKF bearings represent a large capital investment.
In order to achieve higher device performance and minimum maintenance costs reliably, must follow the correct approach. This included SKF bearing storage, clear, clean, test and install.
Any bearing service life depend to a large extent on maintenance and care it receives. In industrial applications, in particular, are often poor working conditions, loads, dust and pollution is a common scale.
Applies to all anti-friction bearing design. Store bearing SKF bearings with special anticorrosion coatings are available, but the majority of SKF bearings do not prevent corrosion materials. In the handling and storage of bearings, care must be taken to ensure that they will not rust or corrode. Even wet or unprotected chemical gloves left by hand or a small amount can cause etching in a small area, this may lead to bearing fatigue.
New and restructured shipped bearing a protective coating, usually covered in a protective paper or other packaging, and shipped in a carton or wooden boxes. When you receive a new or remanufactured SKF bearings, does not remove it from the packaging until ready to install the application.
(1) injuries and its control approaches
Scrolls the appearance of rolling bearings are subject to cracking, creasing or rust, on episodes like rivet rivets that periodic vibration and noise, the cycle can be fixed but most must correspond with the speed, scars are continuing attacks on the channel, scars on the ball disappeared, and this premise installation and smooth the noise but without a necessary change.
Such moderation approach to noise: device not tap bearing, SKF bearings and shaft assembly after installed into housings from SKF bearing slant; inventory to avoid corrosion of bearings and transport to avoid vibration and shock to use smooth fat for high viscosity.
(2) dust and its control approaches
Rolling bearings with dust and other foreign bodies, will attack non-periodic oscillation and the so-called dust, vibration and noise of the large and variable, and with or without.
Moderation approach to dust: improving the washing of SKF bearings, bearings, shafts, holes before installation, as well as match part all stringent clean Shen Qing; out foreign bodies smooth agent; improve bearing seal; preventing impure or embedded with foreign objects using information the plastic stick.
(3) lubrication factors cause noise and its countermeasure
Selection errors, lack of lubricant or lubricant ageing attack induration, SKF bearing vibration and noise, this noise and no rules. This situation, as long as the selection of appropriate smoothing agents, adjusting its smooth-dose extended smoothing agent for change determination and application life cycle.



Other News:
SKF bearing handling attention issue
NSK bearing noise test method
Bearing selection need to be aware of the problems
Bearing operation effect check lubrication method
Transmission maintenance of deep groove ball bearing life extension
Reducing bearing noise maintenance lubrication method
Precision bearing load capacity
Heating in the bearings fault