Bearing life is closely related to the manufacture, Assembly, use, must be good at every aspect to make bearings in top running condition, thus prolonging the service life of the bearing.
It should be pointed out is that link of the bearing lubrication and cleaning is very important. So when we raided the former bearing, of the benjamites clean bearing profiles, and then remove the bearing around the part. Masters should note that oil seals are parts of cowardice, fruit being confiscated and split split non paged special care is required when use excessive force, that formed part of damage. Then carefully seizure bearing oil seal and neighbouring parts of, if not shown adverse symptoms, be sure to replace the modified, bad oil seals will cause damage to the bearings, bearing clouds formed divisions like equipment downtime.
We also raided the bearing lubricant. Lubrication is very major, not only against the bearing, for the non-bearing. But please note that the bearing should not be adding too much grease. Raids on the bearing lubricant is: James little lubricant on friction between the two, in the absence of pollutants-free, is feeling out; or is coated with a layer of lubricant on the back, and then conducted raids. Then there is the change of bearing lubricants. After oil lubricated bearings are purging old oil, bearing coating removal process described should be. If so, gravity and then poured into the new oil and machinery is low speed reverse for a few minutes. Oil collects residual contaminants as much as possible, and then purging those oils. Note: oil best Britain before end of filter is being used. The use of grease-lubricated bearings are replaced when the grease, except when used by Joe avoid cotton content-free access to any parts of the bearing. Since those residual fibers may wedge between scroll and formation damage what bearing defects induced by lifting elements, especially small bearing service must pay attention to this issue.
(1), bearings, to keep their environment clean.
Even if the eyes do not see the tiny dust, would have a negative impact on the bearing. Therefore, to keep surroundings clean so that dust will not be penetrated bearing.
(2), use with care.
Bearings in use to give a strong impact, there will be a scar and indent FAG bearings frequently asked questions, cause of the accident. Serious cases, crack, break, be sure to note.
(3) angular contact thrust ball bearings, using the appropriate tool.
To avoid existing tools, rather, you must use the correct tools.
(4) attention to bearing corrosion.
Bearing operation, will rust because sweat. Pay attention to the clean hands operation, bearing coating removal process described should be. The best possible wear gloves.
Bearing failure for a number of reasons, all the design and manufacturing process and effect of bearing failures, their analysis is not easy to determine. In normal circumstances, in the General case, you may want to consider and analyse the factors and internal factors.



Other News:
Several major problems bearing on the common
Radial internal clearance of the bearing impact on operation vibration
Bearing FAQ control methods analysis
Common adjustment method of bearing installation
From color, touch, look at three points to identify maintenance effect of bearing
Negative effects of bearing temperature is too high
When the bearing damage failure of maintenance measures
Maintenance method of surface fatigue failure of angular contact ball bearing