Generally, SKF bearings if used incorrectly, you can use up to reach fatigue life. But there are accident prematurely damage, not in use. This early damage and fatigue life, known as the quality limits of breakdowns or accidents. Result from installation, use, not paying attention on the lubrication from outside intrusion by foreign bodies, shafts, case study on thermal effect of inadequate.
On the injury status of FAG bearings, such as roller bearing rings of ribs hurt, as a reason to consider, for oil lubricant inadequate, inappropriate, construction defects, intrusion of foreign bodies, spherical ball bearing misalignment, shaft deflection is too large, there will be these reasons coincide.
1. the sound of rolling bearing using acoustic logging on the size of the sound of rolling bearings in operation and sound checks, even has a slight peeling of the bearing damage, also is making an abnormal sound and irregular sound, using sound system to be able to tell. According to the self-aligning ball bearing load grease when you select, for heavy-load small grease should be selected for penetration. By lubricating oil recycling, can take a lot of heat.
2. oscillation bearings for bearing vibration are sensitive to NSK bearings failures, such as indentation cracks, wear, corrosion, spalling, are reflected in the bearing vibration measurement, therefore, through the use of special bearing vibration Measurer (frequency Analyzer, etc) measures the size of the vibration, through frequency not infer exceptions to the specific situation.
3. grease lubrication grease is made up of base oils, thickeners and additives for lubricants. In order to reduce this impact must achieve on the high speed shaft bearings well lubricated bearing TIMKEN bearings temperature the temperature of the bearing outside of room temperature can be speculated, if using oil hole can directly measure the temperature self-aligning ball bearing outer ring, is more appropriate.
4. Select when grease is selected according to the operating temperature of the grease, key indicators should be dropping point, oxidation stability and low temperature performance, high temperature drop point usually used to evaluate performance, bearing the actual temperature should be below the drop point ℃ 10-20. One detachable flat washer retaining ring, or portions therein as self-aligning ball bearing outer or inner ring of a rib when selected, is ideally suited for bearing should be selected using criteria moisturizing oil, due to the different trademarks, will also have a lot of differences in performance, so when choosing, you must be careful.
Therefore, only investigate INA bearings damage, it is difficult to know the real causes of injury. However, if you know the bearing condition of used machinery, used, constructed around the bearings, understanding of the situation before and after the accident, combined with self-aligning ball bearings damage State and investigation for several reasons, they can prevent similar accidents happening again.



Other News:
Self-aligning ball bearing method of injury countermeasures and check processing
Tapered roller bearings the basic judgement of the quality approach
Linear bearing features and technical information
Thrust ball bearing grease the main way to detect deterioration
Self-aligning ball bearings are used to avoid high temperature through a four-point pay attention to matters
Bearing performance and core technology
Roller bearing temperature measurement methods
Precision bearings and plain bearings size requirements