In nearly all Igus Chainflex cables, the conductors are bundled to eliminate problems associated with cables constructed in layers.

Cables constructed in layers are significantly cheaper to produce, therefore some manufacturers offer continuous-flexing cable with this low-cost approach.

However, Igus said thatthese cables are often constructed without attention to pitch length, pitch direction or centre-filler design and typically have fleece wraps and binders with a sleeve-extruded jacket.

In a short travel, long-travel gliding or other demanding flex applications, they tend to fatigue and their insulation and jacket compounds lose their tensile and elongation properties.

This greatly reduces service life.

As these materials break down, the cable core is compromised and the torsion forces of the cabled conductors release and untwist in parts of the cable.

This causes a 'corkscrew' effect.

The risk of such problems is increased with cables that have multiple layers (usually more than 12 conductors).

With Igus Chainflex cables, the conductors are bundled rather than layered.

The wires are twisted with a special pitch length and the resulting conductors are cabled into bundles.

For large cross sections, this is done around a strain-relief element.

The conductors are then bundled around a tension-proof centre.

The multiple bundling of the conductors changes the inner radius and the outer radius of the bent cable several times at identical intervals.

Tensile and compressive forces balance one another around the centre rope, which provides inner stability.

As a result, the cable core remains stable even under maximum bending stress.

Other News:
RA Rodriguez Takes a Stand at DESi 2009
Igus Continuous-flex Cables Use Bundling Technique
Barden Plant Gets CAA Approval
GGB Bearings Brochure for Polish Market
Timken Commissions Expanded Bar Mill at Harrison Steel
Inpro/Seal Introduces New Current Diversion Ring
Rexnord 6000 Series SHURLOCK Adapter Mounted Bearings
Schaeffler Says Continental Merger Still on