A recent technical bulletin by SKF provides information for properly cleaning and maintaining bearings.

Proper bearing cleaning can mean the difference between good performance and bearing failure. If cleaning is done improperly, the bearing, shaft or housing may become damaged, creating a more costly repair job.

While it’s important to handle any bearing with extreme care, SKF highly recommends following these specific procedures when cleaning bearings.

Step 1
To begin the cleaning process, soak the bearings in a metal basket suspended in a clean container or tank holding a recommended solvent soaking the bearings overnight, if possible. If a basket is not available, suspend the bearings with a wire, or place them on a metal plate at the bottom of the container. Do not rest the bearings directly on the bottom of the bucket (they may not clean as efficiently due to sediment on the bottom of the container).

Step 2
After dirt and grease are removed, rinse the bearings in another clean bucket of solvent (See Figure 1). The bearings should then be thoroughly dried. The safest method is natural air-drying. Compressed air, which is free from condensed moisture, may be used to blow out the bearings, but only after all dirt and chips have been removed (See Figure 2). If compressed air is used, do not allow bearings to spin and always wear safety glasses to protect your eyes from injury.


Step 3
After cleaning, inspect the bearing thoroughly for nicks, leftover dirt, and damage. Inspected bearings, which are considered “good” may be used again. However, if re-assembly cannot be done immediately, these bearings should be protected.

Step 4
Dip the cleaned bearings in a protective lubricant, or coat all surfaces with a light grease (See Figure 3). Rotate each bearing to work the grease thoroughly in and around the roller and on the races. Then wrap the bearings in waterproof paper and place each in a clean box or carton (See Figure 4). If cartons are not available, just wrap them in waterproof paper. Mark the outside of each package to identify the bearing enclosed.

4). If cartons are not available, just wrap them in waterproof paper. Mark the outside of each package to identify the bearing enclosed.

For a closer look at SKF products and services, visit www.vsm.skf.com.

Other News:
FAG Spherical Roller Bearings Selected for New Retractable Roof at Wimbledon’s Centre Court
SKF Offers Tips for Proper Bearing Cleaning and Maintenance
Schaeffler Offers Rolling-bearing Services
SKF Relocates UK Bearings Unit to Italy
KGJS's Kongsberg Bearing Wear Monitoring System for SKS Newbuildings
NTN Corporation - Financial and Operations Review - Companies and Markets New Analysis
GreaseMax Solves Electric Motor Lubrication Issues
Ceramic Bearing Constructions from GLYNWED Brings New Possibilities