IKO bearings overheating phenomenon should cause everyone vigilant, do not be careless.

IKO bearings overheated caused mainly due to the following aspects:

(1) IKO bearings have been damaged and should be replaced immediately.

(2) IKO bearing grease is too little, too much or scrap iron and other impurities. The capacity of the bearing axis of the grease should not exceed 70% of the total volume of the impurity should replace.

(3) shaft bearings with tight or too loose. Too tight, should be re-grinding shaft should be too loose to casement.

(4) IKO bearings and cover with tight or too loose. Tight when processing bearing chamber, inlaid steel sleeve in the end cap is too loose.

(5) The motor end caps or bearing cap assembly adverse. Cover or bearing cover the mouth stuffed into loading level, tighten the screws.

(6) the belt is too tight or coupling assembly adverse. Adjust the belt tension correction couplings.



Other News:
Cause IKO the bearing overheating different tone analysis and solution
The cost of support weakened against the steel market downturn threat
Rolling residual magnetic conditions | Qi Si Dadi bearings
The bearing metal noise | Qi Si Dadi bearing
Decline in machine tool orders in Japan in July this year, but monthly orders st
Steel futures to help spot businesses out of financial difficulties
Multi initiatives to adjust and optimize against the steel market downturn threa
Japan and South Korea FTA negotiations consultations ＂differences remain＂