FAG bearings after installation, in order to check the installation is correct, the operation check. Small mechanical hand rotation, to determine whether the rotation smooth. Inspection items nick, indentation caused by dysfunctional torque instability, arising due to poor installation, mount processing bad due to the clearance is too small, installation errors, and seal friction torque and so on. If there is no exception, you can start the power operation.
Large machinery can not be manually rotated so cut off the power immediately after the no-load start, idle machinery, check for vibration, noise, rotating parts in contact to confirm that no abnormality, the power operation.
Power operation, start from no-load low-speed, slowly increased to the conditions stipulated in the rated operation. Test run to check the matters, whether there is abnormal sound, FAG bearing temperature changes, lubricant leakage or discoloration. If abnormal, should be immediately discontinued operation, check the mechanical, if necessary, to remove the bearing check.
FAG bearing temperature, and can be speculated that under the external temperature of the bearing. However, the use of hole directly measuring the temperature of the bearing outer ring is more accurate. Bearing temperature gradually increased from the operation, usually 1 to 2 hours after temperature stabilization. If the bearing is bad installation, the temperature will soar, and abnormal high temperature. The reason lubricant such as excessive bearing clearance is too small, poor installation, and sealing devices friction is too large. High-speed rotation of the occasion, FAG bearing structure, the lubrication mode select error is also the reason.
FAG bearings, rotating with a stethoscope and other examination, a strong metal noise, abnormal sound, irregular sounds and other description of an exception. The reason for poor lubrication, poor shaft or bearing accuracy, bearing damage, dust and debris.
FAG Bearings common fault as follows:
1, tile surface corrosion: the spectra showed abnormal concentration of non-ferrous metal elements; many non-ferrous metal composition of submicron wear particles in the iron spectrum; excessive lubricant moisture, acid value exceeded.
2, the journal surface strain: iron cutting abrasive or black oxide particles in the iron spectrum, the metal surface tempering color.
3, the journal of surface corrosion: the spectra showed abnormal iron concentration and iron content in the sub-micron particles in the iron spectrum, excessive lubricating water or acid value exceeded.
4, the surface strain: Ferrography cutting abrasive, abrasive ingredients for non-ferrous metals.
5, tile back fretting wear: spectra showed abnormal concentration of iron, the iron spectrum many iron content in the sub-micron wear particles, oil water and acid value exception.
Conditions of liquid lubrication, sliding surface lubricant to separate without the risk of direct contact, but also can greatly reduce the friction loss and surface wear, the film also has a certain vibration absorption ability
Other News:
FAG bearings running check
Society of steel inventory to fall year-on-year growth rate to continue to enlar
Japan IKO bearings seal selection characteristics of commonly used materials pro
U.S. First Lady ＂Michelle was the＂ death threats ＂
How to determine the cause of the malfunction of INA cylindrical roller bearing
The viscosity of the grease on the use of performance impact
People's Daily: the Philippines and Vietnam, and Japan is a provocation given to
Japan said that short-term recall of Ambassador to China is not a protest agains
