(1) force work together as much as possible through the axis of IKO bearings, which requires a springboard for symmetrical and smooth, spherical or parallel to the axis of force.

(2) the size of the force should be steady and uniform, not impact, which requires the use of hydraulic or with tools able to exert a steady pull or pressure, really had to use hammer, but also by the relatively soft copper sleeve, of scrap metal to be buffered by a percussion force gently as possible. The best use of brass or copper hammer for hammering.

(3) to avoid through the rolling force, which requires disassembly inner ring (shaft washer) through the inner force, when disassembly outer) through the outer force.

(4) drag force to continue until it should, for example, the installation of IKO bearings, IKO bearings just fitted to the correct position to stop the force, to ensure the end of the ferrule (washer) is against the housing bore or shaft shoulder block end, both can not be packed too tight, can not be installed in place.



Other News:
Assembly and Disassembly IKO bearings of the main points of the force
Spain announced 65 billion euros a new round of austerity plan
INA cylindrical bore bearing installation method
Gamesa to complete the construction work of the 74-megawatt wind power project i
Detection IKO linear bearing quality is good or bad few errors
Italy intends to apply for bailout funds to buy government bonds
Diaoyu Islands, if the war is small to play or big hit?
The introduction of the cage in the INA bearings and other parts and materials