(1) force work together as much as possible through the axis of IKO bearings, which requires a springboard for symmetrical and smooth, spherical or parallel to the axis of force.

(2) the size of the force should be steady and uniform, not impact, which requires the use of hydraulic or with tools able to exert a steady pull or pressure, really had to use hammer, but also by the relatively soft copper sleeve, of scrap metal to be buffered by a percussion force gently as possible. The best use of brass or copper hammer for hammering.

(3) to avoid through the rolling force, which requires disassembly inner ring (shaft washer) through the inner force, when disassembly outer) through the outer force.

(4) drag force to continue until it should, for example, the installation of IKO bearings, IKO bearings just fitted to the correct position to stop the force, to ensure the end of the ferrule (washer) is against the housing bore or shaft shoulder block end, both can not be packed too tight, can not be installed in place.



Other News:
Assembly and Disassembly IKO bearings of the main points of the force
South China Sea Fleet live ammunition to destroy multiple batches of incoming mi
Obama cast the tax cut issue has been the Republican Party refused to start anot
INA joint inspection of the bearing damage analysis
＂Slow invasion of the South China Sea behind a mission
Construction steel decline is difficult to slow an endless stream of low-cost re
Chinese fishery boats into the Diaoyu Islands, 12 nautical-mile was the Japanese
The East China Sea exercise possession of shaking secrets: Japan completely igno