Maintains the bearing is the circular cone roller bearings revolution essential condition, the commonly used maintenance was aims at the IKO bearing the lubrication, how in read chooses the bearing the lubrication way, in had understood under the bearing lubrication way premise, also has the necessity very much to the bearing system maintenance understanding, below let us look how carried on the bearing lubrication maintenance.

1. maintains the cleanness which the bearing lubricates
Carries on before the inspection to the circular cone roller bearings to have to be first clean the bearing the surface, then careful inspection bearing oil seal and peripheral components, if has presented time not the good symptom, replaces by all means must, not the good oil seal can cause the damage, causes the IKO bearing cloud type to create the equipment not not normally the engine off.

2. attention cover exposition bearing
When inspection circular cone roller bearings do not have to let the bearing expose in the pollutant or the moisture environment.If time discontinuation of work, should model the film or the similar material by the oiled paper duplicate once the machine.But if in does not need the disassemblage possibly to carry out under the inspection situation to clean the not concealed bearing, must paint the brush which uses to stain the petroleum spirit clean, again the cotton material which does not bristle by one dries or with the compressed air air-dries (attention not to have to let bearing module start revolving).That kind of probe use which by a small mirror and the similar dentist inspects orbital plane of, the retainer and the bead the IKO bearing.Cannot clean adds the sealing gland or the dustproof bearing; Only cleans its exterior surface then.If the bearing assumes time the damage situation namely must replace.Replaces the bearing in the regular engine off maintenance time far because the sudden engine off which received the damage to elect loses the economy to be more than.

3. inspects the bearing the lubricant
Not only the lubricant is very important aims at the bearing, also aims at all bearings.But please note, the circular cone roller bearings add excessively many lubricants not suitably.Then was replaces the bearing the lubricant.The use machine oil lubrication bearing in flows swiftly after the old machine oil, if may the speech, must again pour into the fresh machine oil and let the machine revolve several minutes in the slow-speed of revolution.Causes the machine oil collection remaining pollutant as far as possible, then flows swiftly again eliminates these machine oils.But uses the hard fat lubrication the IKO bearing greases when the replacement, uses Qiao eliminates should avoid having cotton material contact bearing any spot.And because these residual textile fibers possibly key on in roll between the moving parts to create the damage, the bearing application must pay attention to this question especially.

Part waviness between bearing race and bearing seat or drive shaft in dense coordinate situation, the bearing race has the possibility and the neighboring part outside configuration coordination distorts.If appears the distortion, then possibly has the vibration in the movement.Therefore, carries on the bearing seat and the drive shaft the common difference which the machining arrives needs to be very important.

Because the partial damage operates or the installment mistake, the small partial bearing roller conveyer and the rolling body possibly can suffer injury.In the movement, rolls the damage bearing part to be able to have a specific vibration frequency.The vibration frequency analysis may distinguish the damage the bearing part.In the application situation vibration behavior in many applications, the IKO bearing rigidity and periphery the structure rigidity is same.As a result of this characteristic, so long as chooses the bearing correctly (including pre-load and windage) and in the application disposition, has the possibility to decrease in the application the vibration.




Other News:
Vibrates the maintenance examination method to the IKO circular cone roller bear
High temperature high speed INA turntable bearing lubrication maintenance knowl
The joints IKO bearing damage using the life-cycle analysis
Burning straw causing fog-making how to ＂trash to treasure＂?
The correct use lubricant the importance which revolves to the SKF bearing
Chinese general suggested Diaoyu Island lets the Chinese and Japanese armament p
Adjusts the bulbus cordis bearing breakdown reason and the revolution inspection
For the Dalai Lama's suspension of ministerial-level meeting between Britain and