Thrust bearing Assembly main subjected to axial loads, it widely. Although the thrust bearing installation is relatively simple, but still often errors occur when the actual repair, tight ring and loose rings of bearing installation location is incorrect, with the result that the bearing failed, journal wear very quickly. Inner ring and shaft for transition fit tight ring, when axis driven tight ring and friction with the static end, subject to axial force (Fx), moments of friction moment appears larger than the bore diameter combined with resistance, resulting in tight ring and shaft meet mandatory rotation, axis neck abrasion.
　　 Therefore, installation should pay attention to the following several points of thrust bearing.
　　 (1) separate the tight ring of the bearing and loose ring (according to the bearing bore size to judge, Aperture differ by O.1~O.5mm).
　　 (2) still distinguish institutions (that is, not part of the campaign, mainly refers to the Assembly).
　　 (3) no matter what the situation, loose rings should always be on the static parts of the bearing on the end.



Other News:
The IKO miniature bearing expires three intrinsic reasons
Thrust bearing installment matters needing attention
Improper treatment of affecting stable operation IKO miniature bearing vibration
KOYO bearing material
Analysis of the effects of interest rate cuts on the steel market
How distinguishes the IKO knuckle bearing burn breakdown reason analysis
Sand steel mid-June partial product price policy
NSK bearing steel technology and directions