A, IKO bearing vibration

IKO bearing vibration on bearing damage is very sensitive, such as peel, indentation, rust, crack, wear, etc, will be bearing vibration measurement in reflected in, so, by the use of the special bearing vibration measurement device (frequency analyzer, etc) can measure the size of the vibration, through the frequency points not that abnormal specific situation. The measurement of numerical of bearing conditions of use or sensor installation position and different, so need to every machine in advance of the measured value analysis is made after the judgment standard.

Second, IKO bearing temperature

Bearing temperature, usually have a bearing the outdoor temperature that out, if use oil hole can directly measure IKO bearing outer ring temperature, is more a suitable.

Usually, the temperature of the bearing with IKO running bearings began to slowly rising, 1-2 hours to achieve stable state. The normal temperature of the bearing capacity of the machine, heat, speed and load and different. If the lubrication, installation of appropriate, the temperature will rise abruptly IKO bearing, would appear abnormal high temperature, then must stop operation, and take the necessary measures to prevent it.

The use of thermal can supervise IKO bearing temperature, and realize the temperature more than e. automatic alarm or stop when to prevent burning shaft accidents.

With high temperature often said IKO bearing is already in the abnormal situation. High temperature is bad for bearing lubricant. Sometimes the bearing can be on the overheating bearing lubricant. In more than 125 ℃ if bearing temperature even reduce long-term transfer IKO bearing life. The reason caused by high temperature bearings include: lubrication is insufficient or too lubrication, lubricant. Contains impurities, load is too large, bearing loss loop, the gap is insufficient, and oil seal of high friction produced, and so on.

So the continuity of monitoring IKO bearing temperature is necessary, whether measurement bearing itself or other important parts. If it was in operation condition under the condition of invariable, any change in temperature can be expressed already failure.

IKO bearing temperature measurement can be regularly with the help of in the thermometer, such as digital thermometer, can accurate measurement temperature and in ℃ or bearing Fahrenheit temperature will display unit.

The importance of the IKO bearing, means that when the damage, can cause equipment of down, so this kind of bearing should be the best temperature probe.

Normally, IKO bearing in just lubrication or again after the lubrication can have natural temperature rise and last for a day or two.




Other News:
IKO bearing vibration and temperature judgment bearing damage
Iron ore price declines CVRD was affected
Electric KOYO bearings cleaning process and the matters needing attention
Bearing the cause of the phenomenon and the temperature, processing
High temperature cause KOYO bearing fault reason analysis
Superior bad discard steel trading industry is inevitable and necessary of hards
High quality NSK bearing the smelting of imported material requirements
Conflicts between supply and demand of the endorsement steel mill ＂to＂