Bearing lubrication is best in equipment downtime during the plan implementation, and periodic supplements. Clear out the old grease or through the drain plug agent of the old grease out. The nozzles are cleaned before adding new oil. Bearing box to the nozzle of the device, you should open the bearing cover or end cap in order to remove the old grease, and then add the same fresh grease.

    Oil lubrication

    View the bearing oil, make sure to use the correct oil type and oil vent is blocked.

    Remove a small amount of oil as a sample and compare and fresh oil. If the sample appears cloudy, it may be the result of water mixing, should be replaced. If the sample was darker colors or thickens, it may be said oil start carbonation. The old oil should be all replaced, if possible, use fresh oil to flush the bearings. Change the oil at the same time should ensure that the replacement of oil type must be the same, and added to the required oil level.

    A more reliable method to determine the oil condition is the analysis of samples, if the oil is contaminated you should replace the seal or consideration Lu device.

    Oil bath lubrication system, if the operating temperature does not exceed 50-60 degrees and the oil is not contaminated, and then replaced once year oil can. If the operating temperature of 100 degrees Celsius, the year the replacement of

Other News:
Bearings lubrication
Bearing fatigue crack development process
Bearing retainer
Loaded nylon to keep the aircraft bearing
Rolling bearings and sliding bearings classification
Rolling bearing assembly process
Sliding bearing material
Fasteners select material