1.      To understand the shape and connection size of the variable speed drive FAG Bearings.

2, variable speed drives FAG Bearings can be horizontal placement, can also be vertical or tilted placement. 
3, the variable speed drive FAG bearings regardless of which installation, coupled to have the size to meet the requirements.

Recommended:

Inner hole d and shaft with the press H7/h6;

In the ring, pin holes do drive with the press H7/r6;

The outer ring D and the shell with H8/h7;

The transmission output shaft hole with clearance fit clearance of 0.2 ~ 0.5mm.

4, the axial positioning of the variable speed drive FAG Bearings: the circle three times any axial location; the other two axes do not need to axial position.

5, rotational orientation; outer ring and inner ring are the positioning of the flat key. In the circle is the use of the positioning of the drive.

6, variable speed drives FAG bearings in the radial direction can be subjected to a smaller force, but should not bear a greater workload.

7, the transmission ratio, are according to the first installation of the transmission ratio. Use other installation methods; you should calculate the transmission ratio.

8, at the rated speed (1500rpm), according to the transmission ratio and the required power (KW select a variable speed drive FAG Bearing.

9, when the working torque required corresponding selected model.

10, the reducer model selection should be consistent with the model of the variable speed bearings.



Other News:
The variable speed FAG Bearings note
Bearing on its structure determined the noise
The results of the classification bearing performance characteristics
How to properly maintain SKF bearing
The rolling bearing heating install detailed introduction
INA bearing corrosion causes and prevention measures
The usual way to indentify the bearings quality
How to choose the sliding NTN bearings grease lubrication