Pump (1) put into use, the general to be replaced after 100 hours of running grease (oil), after each run 500 hours to replace.

(2) the flow of bearing grease lubrication, operating after 1500 hours, should be replaced grease filling the oil is not too much or too little, because the grease too much or too little will cause the bearing heating, refueling general grasp in the bearing chamber volume of 1/2 to 2/3 is appropriate.

(3) For lubricating the bearings, the oil should be added to the specified location.

(4) Sheng lubricating oil or grease to be a clean container, usually sealed, there should be no dust, iron filings and other debris, so as not to damage the bearing.

(5) Motor bearings generally use sodium based grease, the characteristics of this grease is able to heat (125 ° C), but easily dissolved in water, it can not use it for lubrication of pump bearings.



Other News:
Bearings in the pump during use and maintenance methods
Lubricants simple detection method
Performance and use of various types of bearings
Solid lubricated bearings
Sealed bearings performance influencing factors
FAG bearings during the installation process need to pay attention
SKF bearings installed with high-speed bearings and adjustment、
SKF code