FAG Bearings before the inspection, and inspection is also used by some to be the amount of blocks, standard parts and measuring instruments co-located on the premises of a metal inspection plate, so that these objects can be quickly temperature and room temperature of homogenization. Has dried or dried FAG bearings, should be required to be delivered immediately check the oil drops, no time FAG bearing outer surface protection film, the entire inspection process staff are not allowed to directly touch the skin, the operator should wear clean gloves, or hand painted with anti-rust agents, but must be avoided in the hands of anti-rust agent mixed with FAG rolling bearing surface, otherwise it would be measured deviations occur.
    FAG Bearings to be delivered in the routine examination before they can remove their seal packaging before, and oil immersion washing with 3% acid-free gasoline or kerosene, turn theouter ring and carefully wash their cage, rolling elements and raceway junction, require any previously hidden parts of the residual traces of oil thoroughly cleansed. FAG Bearings shall be attached after the wash clean and dry cleaning Moulin, lined with clean neutral liner on the bench to dry, or slowly in the far-infrared drying oven. Since even dry cleaning Youlin dry or drying, the whole process should not turn FAG bearing rings, rolling elements, or any cage.
FAG Bearings After the inspection, should be delivered immediately or rust inventory process, the entire inspection process should be to accomplish, so as not to last too long cause corrosion. Note the use of pure gasoline without oil washing can also cause corrosion.



Other News:
The key of FAG bearing repair and maintenance
Bearing body the rolling sound technical analysis
Hot and cold installation of bearings
Bearing use and environmental conditions
Characteristics of ceramic bearings four classifications introduced
FAG rolling bearing several common configuration
The type of rolling bearing vibration introduction
Pretreatment of the bearing surface rust