1, the output shaft gear transmission parts in the installation, you must pay attention to operation of the soft, prohibit the use of a hammer and other rough tools installed, it is best to use the assembly fixture and end within the threaded shaft installation, to the strength of the bolt screwed into pressed into the gear transmission parts, which can protect the gearbox internal parts will not be damaged.

     2, the reducer in the installation, paying particular attention to driving on the center axis of the error can not exceed the speed reducer used in coupling the use of compensation. Reducer in accordance with requirements of, you can get better results and longer transmission life.

     3, the fixed gear is very important to ensure smooth and solid, in general, we should gear mounted on a base or base level, and ranked the oil tank should be excluded, and the cooling air circulation flow. Fixed gear is not good, based not reliable, there will be caused by vibration and so on, will make unnecessary the bearing and gear damage.

     4, gear coupling used in a variety of optional types, but best not to use steel of fixed coupling, this type of coupling is more difficult to install, once installed properly will increase the load capacity, easily lead to bearing damage, and even cause the output shaft fracture.

     5, the gear is installed to ensure the operation of the staff, including the ability to easily close the cursor, ventilation and other plug and oil drain plug location. Reducer of the installation is complete; the inspectors should be installed in accordance with a comprehensive inspection of the location of the order of accuracy, to determine the reliability of each fastener.

     6, before running gear, it’s ready to run, to remove the oil tank vent plug replaced breather plug, open the oil level check plug screw oil line height, more than the oil level plug to add oil to the screw hole overflow, then twist and to determine the correct oil level plug, you can start trial run.

     7, the transmission gear coupling parts in the installation of protective devices should be necessary, for example, couplings or protrusion on the gears, sprockets and other transmission, if the output of the radial bearing load by greater use should be enhanced.



Other News:
Reducer installation essentials
Judge bearing quality five methods
NSK bearing regular inspection methods
Valve works
Fasteners select material
The cause of motor bearing rust
Stainless steel fasteners locked processing
Bearing failure mode