Mill roller bearing support lubrication problem, is a very to solve the problem. Rolling mill bearing for low speed and heavy type lubrication. Our country rolling mill bearing common problems, one is the boundary lubrication problem; It is strongly impact load problem; Three is water and the invasion of the debris and cooling problem. Qingdao rui fine bearing mechanical and electrical introduced several identify common methods of bearing quality because of the big three of the existence of the problem, the bearing wear fast, appear even holding shaft phenomenon. To often want to stop maintenance, oil, production affected, big economic loss, stop loss.

To solve the above problems, many institutions are studied, also appeared many plans, but still not very ideal.

We recommend you to use 8 O8 nano antiwear (extreme pressure) agent method. There will be significant effect.

8 O8  anti-wear agent, is a kind of nano type ball (extreme pressure) anti-wear agent. NSK bearings fixed a party radial or axial movement of the amount of it when mobile crushing strength, as high as 1500 MPA/CM2, it's no card bite the load, and is very high, for the past two or three times the gear oil. According to * * university do similar test, as long as in the original use in lubricating oil 6 to 12% of the 8 add O8 nano anti-wear agent, can greatly improve the lubrication, bearing the compressive, shearing, pitting corrosion, peel, overheating, so as to extend several times to the life of the bearing, reduces the noise, smooth operation, saving power. Power consumption, noise and vibration, bearing temperature are different degree of decline. Also, can also points to join many times in grease.

Its mechanism is: in the process of operation, bearing industry and other industry for domestic and imported goods analysis for 8 O8 nano anti-wear agent at the contact point place, can produce nanometer reaction film, its intensity is far higher than the traditional chemical reaction film, long and firmly in bearing on adhesion, and can produce nanometer ball, such, will enhance and improve the lubrication problem of mill:

1, make bearing cone set and lining suites cannot directly contact, it's fully, lasting and reliable lubrication, effectively put an end to the boundary friction, dry friction, overcoming the bearing no oil lubrication state;

2, increased the load bearing real contact area, improve the bearing capacity and impact resistance;

3, lubrication methods to give priority to the ball lubrication mixture lubrication, FAG bearings use should pay attention to the items attached to the strong, is much better than film lubrication, friction resistance is reduced, friction loss is greatly reduced and the energy consumption decreases; To solve the pollution or insufficient lubrication under the condition of the bearing life problem;

4, friction loss reduction, bearing no longer a problem heat;

5, 8 O8  anti-wear agent is higher than 230 ℃ mouth flash point, difficult to burn, in room temperature, with MingHuoDian not, their own will not fire burning;

6 and 8 O8 anti-wear agent, good resistance to corrosion resistance, rust and froth performance and oxidation stability; Was, copper corrosion 100 ℃ ╳ 3 h, for 1 a. Non-toxic, not spontaneous combustion, the mechanical and the human body is noncorrosive, without sequelae, but need to prevent it.

7 less downtime, rolling mill, oil cycle extended, production will no longer be affected, saving electricity consumption obvious, improve the production efficiency and economic benefit is improved.

 
8, 8 O8  anti-wear agent of another characteristic is to teach you some methods to distinguish true and false bearing, even in the operation of it from the small amount of water, water on the lubrication effect is very limited, and need not replaced immediately or maintenance;



Other News:
808 anti-wear agent in the rolling mill bearing applications
A single row angular contact ball bearing several structure forms
Labyrinth seal mechanism and influencing factors
Bearing type selection of several factors
Precision FAG bearings installed
The installation of the cone bearing hole
Rolling import bearings non-contact seal
Bearing check