To cut costs Kluber high-speed NSK bearing greases

The requirements of the design the bearing grease much less than oil. In the past, grease can only meet speed to 1.3 million high-speed factor SKF bearing application requirements, such as: milling machine, grinder, lathe and drilling shaft, and faster than the value, you have to oil-air lubrication. G ruburt lubricant manufacturing new high-speed grease-Kluberspeed BF 72-23 allow speed to 2.3 million factor. Due to adhesion of the it, it is suitable for the horizontal and vertical direction of the axis machine tools installation. Now, in many cases, all can be used instead of oil-air grease lubrication, thus reduce equipment and operating costs.

 
During operation of the lower FAG bearing temperature is this new type of fat other advantage. Accordingly, Kluberspeed BF 72-23 working life can last longer. Permanently lubricated or longer to lubrication cycle can be quite a lot of cost saving. And, high-speed bearing has cut the temperature of the machine can be optimized design, to help achieve higher quality of production. In addition to machine tools, this new grease can also be applied to electric tools and high speed motor NTN bearing.
 
 



Other News:
To cut costs Kluber high-speed NSK bearing greases
Steel mill stocks have ＂pass＂ signs
NSK bearings rolling to the basic properties of the material requirements
NSK bearing parts of the complexity and accuracy increased rapidly
Debt crisis to Italy
Fill in the outer ring INA bearing gap left by the advanced method
The application of overloading SKF bearing
FAG bearing content focused on enterprise in technology, management and technica